Tools for tiling
can be costly but can make your job faster and easier. If you are not a
professional tiler, it is better to use the right tilers tools Bald Hills if you want to
do everything right.
Here are some
tools you need:
Tile Scribe. A
tile scribe is useful for scoring the glazed surface of tiles so that they break
along the scribe line. A scribe is used against a straight edge to make sure
the scribe mark becomes straight.
Tile Hand Saw. This
is faster than just using nippers in cutting irregular shapes. A tile hand saw
resembles a hacksaw, with a frame that holds the ends of a tile cutting blade.
The distance from the blade to the back of the frame has to be wide enough to
accommodate a cut tile. The tile cutting blade typically has a round section
with cutting edges on every side. Always make the cut on the down stroke and
work from the glazed side of the tiles when working with a tile saw.
Tile Drill.
When drilling glass, mirrors, and tiles, tile drill with special Carbide-tipped
bits are essential. A hand drill is one of the tilers tools Bald Hills, which is useful in
a variable speed power drill. When drilling glass, some form of lubricant is
used to keep the tip cool to form an O ring. It is also used to fill it with
the lubricant so that the tip is slightly lubricated. With the use of a
masonry, ceramic tiles can also be drilled if it is used without hammer action
at slow speed.
Tile Cutter.
This is one of the tilers tools that you can rely on when cutting a lot of
tiles in straight lines. There are many available designs, but the basic type
incorporates a scribe wheel that is pulled across the tile. It also comes with
a breaking arm that is pushed down along the mark after scribing to break the
tile. cutting tiles is quicker and more reliable than using a tile scribe as
soon as you become familiar with using a tile cutter.
When you purchase
a tile cutter, It should be big enough to take the biggest tile being used. The
spare scribe wheel should also be available so that they can easily be replaced
when become worn.
Tile Hole Cutter. It is a good alternative to a tile drill. It has a diamond
cutting edge that meets the tile surface square on.
These hole cutters vary in size from 12 to over 100mm diameter and is suitable
in a power drill, creating a smooth and clean finish. The cutters typically
need to be lubricated with water to prevent the occurrence of premature wear. The
cutter does not have a locating point, making it hard to hold the cutter in
position on the tile to start a hole. You
need to use a cutter in a drill stand or secure the tile.
There are many
more tools that you can use to make your tiling project successful and look
done by a professional.
Comments
Post a Comment